SUBSIM Radio Room Forums - View Single Post

Topp1967 · 03-19-17, 05:57 AM

Returning to SH4 after a long break involving SH3 and WIPAE. Always have used manual targeting and in SH3 used the O'Kane method pretty much as my default. My problem is that when I set my periscope to the shoot angle say 350 degrees for a target travelling from port to startboard, when I hit the send to TDC button the bearing does not change. I've been searching the forums for last three hours and have come up with nothing so any assistance/advice would be gratefully received.

Modwise I am using TMO 2.5 though I doubt that's the issue.

03-19-17, 05:57 AM	#1
Topp1967 Watch Join Date: Aug 2007 Location: Stirlingshire Posts: 18 Downloads: 124 Uploads: 0	Can't Set Bearing Manually Returning to SH4 after a long break involving SH3 and WIPAE. Always have used manual targeting and in SH3 used the O'Kane method pretty much as my default. My problem is that when I set my periscope to the shoot angle say 350 degrees for a target travelling from port to startboard, when I hit the send to TDC button the bearing does not change. I've been searching the forums for last three hours and have come up with nothing so any assistance/advice would be gratefully received. Modwise I am using TMO 2.5 though I doubt that's the issue.