SUBSIM Radio Room Forums - View Single Post

Alien147 · 01-24-16, 08:11 AM

Hello all,

This is just the issue I've hit upon. I figured it was something along these lines. When I run a single mission to test whether the V1.6 patch etc has been applied the additional messages show up. But when I load my career through SH3 Commander, I get the blank messages.

I'd be very grateful if somebody could give me a step by step? I must have managed this before because this was the setup I always used to run but its got me flummoxed this time! I'm not sure what you are referring to when you say H.sie's Commander patch? I didn't see that in the V16B1 install process.

I'm running:

SH3 1.4b
GWX3.0
Intel gfx reflection fix (still playing with an intel graphics chip!)
V16B1 Patch / Supplement to V16B1
O2 gauges V2

Anyway, any help would be much appreciated.

01-24-16, 08:11 AM	#4
Alien147 Watch Join Date: Oct 2011 Posts: 17 Downloads: 71 Uploads: 0	Talk me through it... Hello all, This is just the issue I've hit upon. I figured it was something along these lines. When I run a single mission to test whether the V1.6 patch etc has been applied the additional messages show up. But when I load my career through SH3 Commander, I get the blank messages. I'd be very grateful if somebody could give me a step by step? I must have managed this before because this was the setup I always used to run but its got me flummoxed this time! I'm not sure what you are referring to when you say H.sie's Commander patch? I didn't see that in the V16B1 install process. I'm running: SH3 1.4b GWX3.0 Intel gfx reflection fix (still playing with an intel graphics chip!) V16B1 Patch / Supplement to V16B1 O2 gauges V2 Anyway, any help would be much appreciated.