SUBSIM Radio Room Forums - View Single Post

Jeff-Groves · 11-03-14, 01:58 PM

Need help on what should be a simple thing if I knew what I was looking for.

I'd like ? in the image below to cut the circuit to the switch when the 3.3 to 5 volts power is on.
The pass through voltage for the switch would not exceeded 5 volts and is only used to ground the RX circuit.
The switch is a SPST Normally Open Momentary.

What this does (Or should do) is disable the switch circuit if the USB device is plugged in as that is where the 3.3 to 5 volts is drawn from.

And it needs to fit in here along with the switch.

11-03-14, 01:58 PM	#1
Jeff-Groves GLOBAL MODDING TERRORIST Join Date: Sep 2014 Posts: 5,654 Downloads: 137 Uploads: 0	Any small electronics Gurus here? Need help on what should be a simple thing if I knew what I was looking for. I'd like ? in the image below to cut the circuit to the switch when the 3.3 to 5 volts power is on. The pass through voltage for the switch would not exceeded 5 volts and is only used to ground the RX circuit. The switch is a SPST Normally Open Momentary. What this does (Or should do) is disable the switch circuit if the USB device is plugged in as that is where the 3.3 to 5 volts is drawn from. And it needs to fit in here along with the switch. Last edited by Jeff-Groves; 11-03-14 at 03:48 PM.