Well, my ultimate goal was a full exterior-interior all in one model , but for now I'd be happy with just the exterior. The problem is I couldn't figure out the intersection and combination of the tubes and the hole in the hull. If I just cut a simple circle shaped hole in the hull, it's diameter won't be the same as the torpedo's , obviously, since it's not vertical, thus distorted. I couldn't figure out the way to connect the tube properly with the hole. I found some boolean loop-draw kind of tutorials on intersection of planes, etc, but I can't do it properly, it gets an ugly mess...:-D.
I use Wings 3d by the way.
thx for the quickest reply in forum history
