Quote:
Originally Posted by trebby
I followed as follows:
....
|
From your description, you used Goblin the right way. If you want to make sure that your settings were saved correctly just close Goblin, run it again, open/merge again GR2 and zon files (merging the sim file isn't really needed in your case), and check that the crash depth property is still set to 300.
Quote:
Originally Posted by trebby
I indeed can dive beyond 300m. However Sub is lost because in Zentrale damage area "pressure hull" starts losing Points (from passing 204m on) till it is destroyed. It keeps sinking till "hull integrety" is also "0".
|
Two thoughts:
- how are you testing your changes? Have you made sure that you are performing your diving drills on the same u-boat whose settings you had previously modded?
- single zones' 'crash depth' settings, as set in zones.cfg, override the main settings found in u-boat's zon and cfg files. If you are using RSD, it is possible that Vecko has set some critical u-boat zone(s) to crash at around 200 m though I doubt it.
Quote:
Originally Posted by trebby
You mentioned the ZON files of the Systems, but so far I have not found the pressure hull "decay"depth yet...
|
To the best of my knowledge, there is not a single "pressure hull" zone, but various system and compartment zones. You should ask vdr1981 on how the general pressure hull damage, as shown in the damage management interface, is calculated
