Hello SnipersHunter.
From the readme by TDW:
Quote:
below is already included in my UIs mod
Required menu.txt entries for versions >= v1.0.74.0:
Edit this line in your menu.txt file:
MaxStrings=11100
Add these to the end of your menu.txt file:
; Independent engine controls patch
10025=Shafts
10026=Click to enable/disable speed commands for the port shaft
10027=Click to enable/disable speed commands for the starboard shaft
; Contact report wolfpack patch
11000=Dispatching available submarines to your patrol area|Remain undetected and in a favorable position|Send status reports| |Bdu
11001=All available submarines have been dispatched to your patrol area
11002=Submarines in your area have received instructions to join your attack|Stay in front of contact/convoy, remain undetected, and send regular status reports| | |B.d.u
11003=Remain undetected and continue following contact/convoy|Available submarines are heading to your patrol area
11004=Attain favorable position and shadow contact/convoy until reinforcements arrive
; possible messages from Bdu when can not dispatch subs
11010=No boats are within your patrol area|Act as lone boat| |Bdu
11011=No support within range|Be more aggressive| |Bdu
11012=Contact report received|Act on own data| |BdU
11013=Be more aggressive!| |Bdu
11014=Attack contact| |Bdu
; Reports from dispatched subs
11020=Contact keeper continue to send bearing signals|Group act on own data|Take every opportunity to attack
11021=Convoy in sight|Signal bearing sent|Moving to attack port side
11022=I believe to have made contact with the convoy|Sending bearing signals|Act according to own data|Attacking at full speed
11023=Requesting bearing signal from contact keeper
11024=Beacon signals lie in the line of approach according to dead reckoning.|Attacking far side of convoy
|
You could check your menu.txt file for the entrys and if they are not there edit your file and add the required lines. If you use NewUIs they should be already there I guess.
I hope this helps.
Regards.
Ech
lot.