If you think you didn't get a good install for GWX3, then you certainly should uninstall and do a reg clean-up, and re-install, as desertstriker suggested. Remember to add the .cfg files to SH3 Commander that are needed to use with GWX3. Then take a snapshot of the install using the JSGME function, and run SH3 without using Commander. If all is well, run again, this time with Commander. If still OK, start adding mods, one at a time, until you have the list you want activated. If everything still looks good, then go hunting!
I hope this gets you off the KM's Most Wanted list!
|