Quote:
Originally Posted by Jace11
Not sure what C and D nodes are for, didnt SH3 have Huff Duff so maybe that is D.
|
Yes, this is correct: C nodes werer meant for radar warning receivers, and D for radio direction finders. The new SH5 obj_sensor controller doesn't accept these types. I wonder if using the old SHIII controller on SH5 units would work for the missing sensors
Quote:
Originally Posted by Jace11
With regards to wavelengths I ask because as I understood it radar wavelengths determine target size for detection. Most of the centimetrics in the game are set to detect 0.3 by default and in goblin editor the units are supposedly m2 (that what it says anyway). Centimetric radars were approx 100mm wavelength and 10cm x 10cm = 0.01 m2 i.e many times more sensitive than the 0.3m2 listed.
|
Again, your assumption seems reasonable; going by what I know about wave propagation in general, long wavelenghts would basically "jump" over small targets. However, nowhere I have read that radar
sensitiveness and wavelenght used are in direct relation. On the contrary, most sources I have consulted state that wavelenght has an effect on detection
accuracy which, I think, is a slightly different concept.