SUBSIM Radio Room Forums - View Single Post

Mork_417 · 12-21-12, 08:09 AM

Hey guys, i am looking into doing a project with my SHIII, and if it works, i would love to use it for SH4 too. I've only been reading up on this for about a week now, and I am trying to figure out if it is possible to do the following...

Can these:

(Commands_en.cfg)

[Cmd334]
Name=Set_TDC_bearing
Ctxt=1
----------------------------------------------------------
(Dials.cfg)

[Dial11]
Name=Sol_Bearing
Type=24; DIAL_SOL_BEARING
Cmd=Set_TDC_bearing
Dial=0x3B0D00FF
CrtVal=0x3B0D0001
NewVal=0x0
DialVal=0,360
RealVal=0,360; degrees
Circular=Yes
CmdOnDrag=Yes
SndStep=5
SndList=1,Menu.TDC.Bearing,360

be adjusted so that instead of, or in addition too, the mouse being used to set the values, that i can use two keys to increment the value -1/+1 at a time?

Example: Key "<" = TDC_bearing -1 / Key ">" = TDC_bearing +1

When i was testing earlier today, I tried the following method...

[Cmd334]
Name=Set_TDC_bearing
Ctxt=1
Key0=0x59,s,"Y"

...and all it did was reset the dial/value to 0.

Any assistance or reference material you can point me to will be GREATLY appreciated. FYI, I have no code programming experience what so ever, and the only scripting knowledge i have is batch configuring networking devices, LOL.

Thanks in advance!

12-21-12, 08:09 AM	#1
Mork_417 Lieutenant Commander Join Date: Nov 2002 Location: DB-15 Posts: 851 Downloads: 263 Uploads: 0	Researching feasibility. Hey guys, i am looking into doing a project with my SHIII, and if it works, i would love to use it for SH4 too. I've only been reading up on this for about a week now, and I am trying to figure out if it is possible to do the following... Can these: (Commands_en.cfg) [Cmd334] Name=Set_TDC_bearing Ctxt=1 ---------------------------------------------------------- (Dials.cfg) [Dial11] Name=Sol_Bearing Type=24; DIAL_SOL_BEARING Cmd=Set_TDC_bearing Dial=0x3B0D00FF CrtVal=0x3B0D0001 NewVal=0x0 DialVal=0,360 RealVal=0,360; degrees Circular=Yes CmdOnDrag=Yes SndStep=5 SndList=1,Menu.TDC.Bearing,360 be adjusted so that instead of, or in addition too, the mouse being used to set the values, that i can use two keys to increment the value -1/+1 at a time? Example: Key "<" = TDC_bearing -1 / Key ">" = TDC_bearing +1 When i was testing earlier today, I tried the following method... [Cmd334] Name=Set_TDC_bearing Ctxt=1 Key0=0x59,s,"Y" ...and all it did was reset the dial/value to 0. Any assistance or reference material you can point me to will be GREATLY appreciated. FYI, I have no code programming experience what so ever, and the only scripting knowledge i have is batch configuring networking devices, LOL. Thanks in advance! __________________ Heading to AM49.(U-553)