Ok, as far as the RWR, RADAR & RADIO Masts plus the snorkel - I WAS gonna redo the models BUT - PACK3d cant open the sensor DAT file.
The idea was, that I was going to permanetly fix the RWR to the TOP of the snorkel (where it belongs) and redo the RADAR ARRY so its correct and RAISED and the same deal for the Radio mast. Now I can repossition the RADAR and the RADIO masts BUT with out having ever seen the RADAR ARRY I have no bloody idea if its even there. So all thats left that can be done, is to raise the RADIO mast but since the rest at this stage cant be done, I see no point.
IF I could have opened the sensor dat file, I would have placed a dummy RWR model ontop of the snorkel. I'd have made it a Dummy model that basicaly would always be there on top of the snorkel, that would go up an down with the snorkel. It buy its self wouldn't actually have been the RWR as that would have then been reduced to 1 Vert and saved as a place holder model to go with the RWR when installed.
So until PACK3D's updated (dont hold ya breath) I cant do much more.
Sorry
