I've not been keeping up with things DW as much as I used to, so please forgive me if this phenomenon has been discussed.
I'm running DW 1.01 plus LWAmi 2.03, and I have been testing the FFG's Towed Array down at AUTEC (
) against playable and other modern SSNs modeled in the sim.
Quite aside from the fact that the mod seems to render the FFG TA useless against these SSNs, I've found that marking low-to-moderate signal strength contacts in the TA Single Beam display is not possible. I've had several contacts that showed 3 visible frequency lines in the FFG TA Single Beam waterfall that I absolutely could not mark.
When I changed back to stock 1.01, I was able to mark contacts of similar strength immediately.
I could understand this behavior if the signal was very weak and the frequency line was faint, but the lines I held contact on were quite visible.
Has anyone else seen this happen?
Thanks,
TG