SUBSIM Radio Room Forums - View Single Post

nutworld · 06-16-12, 03:23 AM

Well I have a clean re-install of SH III on my machine, but get a CTD when I run the program. It gets 95+ % of the way loaded and then I get the CTD.

I have tried BOTH exe files, as I did as suggested above and "cut and paste" into my Non (x86) program files folder.

In the Program Files\Ubi\SH III\ exe I get a CTD

In the Program Files (x86)\Ubi\SH III\ exe I get a CTD.

I have not installed any mods or even GWX 3.0 at this point. I have installed the 4gig patch, (I think) as I can't get the exe to run. The install program "said" that it was installed, but again since I can't get it to run, I am not sure.

06-16-12, 03:23 AM	#3
nutworld Engineer Join Date: Nov 2003 Location: Flint, Michigan, USA Posts: 200 Downloads: 92 Uploads: 0	Well I have a clean re-install of SH III on my machine, but get a CTD when I run the program. It gets 95+ % of the way loaded and then I get the CTD. I have tried BOTH exe files, as I did as suggested above and "cut and paste" into my Non (x86) program files folder. In the Program Files\Ubi\SH III\ exe I get a CTD In the Program Files (x86)\Ubi\SH III\ exe I get a CTD. I have not installed any mods or even GWX 3.0 at this point. I have installed the 4gig patch, (I think) as I can't get the exe to run. The install program "said" that it was installed, but again since I can't get it to run, I am not sure.