SUBSIM Radio Room Forums - View Single Post

LGN1 · 11-06-11, 02:16 PM

Thanks a lot for the reply, Stiebler!

If one has to touch the AI_sensor.dat anyway, one could enter values for maxheight that would allow an identification

Anyway, while thinking about it, I remembered that for some sensors the value from the sim.cfg file is used if the value is 0. For sonar this is 100 m^2 in GWX. However, the other sonar parameters differ from NYGM, so it's important for those not using your mod with NYGM to (maybe) adjust the value.

Regards, LGN1

11-06-11, 02:16 PM	#3
LGN1 Ace of the Deep Join Date: Mar 2006 Posts: 1,138 Downloads: 147 Uploads: 12	Thanks a lot for the reply, Stiebler! If one has to touch the AI_sensor.dat anyway, one could enter values for maxheight that would allow an identification Anyway, while thinking about it, I remembered that for some sensors the value from the sim.cfg file is used if the value is 0. For sonar this is 100 m^2 in GWX. However, the other sonar parameters differ from NYGM, so it's important for those not using your mod with NYGM to (maybe) adjust the value. Regards, LGN1