Quote:
Originally Posted by h.sie
Fitzcarraldo: I have tested your Supplement-Mod you sent me. It worked well for me. The debugger showed that the AI-Subs are loaded correctly and I was ordered to shadow the convoy.
But different to you I used a fresh GWX install, only with Wilhelmshaven campaign.
Please try with a fresh install - without that huge MOd list.
Note: My description in the README wasn't clear. I changed it as follows:
Do the following procedure:
- Load Single-Mission "Wolfpack".
- Set time compression to a high value and wait until you see a convoy.
- Send a contact report, keep the distance to the convoy and wait for the reply of the BDU.
- If you are ordered to attack alone, try again: Load Single-Mission "Wolfpack" and....(see above)
An order to shadow the convoy shows, that the AI-Uboats are installed correctly. If, even after 5 or 6 attempts, you always received the order to attack alone, the installation of the AI-Uboats went wrong very likely. Reread chapter 3.2).
That means: If you once are ordered to attack alone, this won't change. Start a new mission instead of sending multiple contact reports. |
Many thanks, Hsie. I have a lot of mods...IŽll make a new installation with GWX only, and IŽll post the feedback.
My campaign SCR file (original), is from Wilhelmshaven v6, Merged Campaign.
Best regards.
Fitzcarraldo
