SUBSIM Radio Room Forums - View Single Post - Lost sea walls at Wilemshaven? d3d antilag to blame or OHII?

Faamecanic · 09-21-11, 10:24 AM

Ok...so I reloaded SH5 and loaded all mods (returned to base immediately and started new mission).

So far on my exit of Wilemshaven I have all sea walls again. But the lighthouse goes in and out (was David Copperfield alive during WWII...disappering lighthouse and all).

I did NOT load antilag...

Guys...is there any way for me to get a hold of TDWs UI 6.7.0 and OHII V1.2? I would like to test to see if its something in the new updates that is causing my issues given that with the previous versions I had 4 solid patrols with no issues (except for CTDs near Wilemshaven..and I think that was a real memory issue..havent had CTDs since I went from FULL to BASE).

09-21-11, 10:24 AM	#12
Faamecanic Ace of the Deep Join Date: May 2005 Location: Off your Stb side with good solution Posts: 1,065 Downloads: 44 Uploads: 0	Ok...so I reloaded SH5 and loaded all mods (returned to base immediately and started new mission). So far on my exit of Wilemshaven I have all sea walls again. But the lighthouse goes in and out (was David Copperfield alive during WWII...disappering lighthouse and all). I did NOT load antilag... Guys...is there any way for me to get a hold of TDWs UI 6.7.0 and OHII V1.2? I would like to test to see if its something in the new updates that is causing my issues given that with the previous versions I had 4 solid patrols with no issues (except for CTDs near Wilemshaven..and I think that was a real memory issue..havent had CTDs since I went from FULL to BASE).