Quote:
|
Originally Posted by gouldjg
@Redwine
What is anum_bold or bold_launcher?. This is what I found in the sensors.sim near the bottom and I presumed it may be decoys but think I am very wrong.
In fact what is a ubold?
Sorry I can not confirm if this is decoy or not.  |
I am so sorry, i feel bad, i was claiming for you, and you with that big problem
sorry.
About your data, it is corect, those are the decoys and decoy launcher.
They was described into SH3Sim.act, but i was not able to found them.
Now we can change its life time, it bubble surface, and may be the decoy noise, it last is hard to do, because is similar to the change of sensivity into AI-Sensors, the hex number is so long.
Any way this may be a help to reduce the Ubber DDs behavior, increasing the decoys effectivity.
Quote:
|
Originally Posted by CB..
if you open the ai_sensors.dat with TT's analyzer and look for the hydrohones sensitivity you find the hex number--
sensitivity = 00000000000400000064000000420000001611FA
problem how do you set that to
sensitivity = 0 ?
is it
sensitivity = 0
or 000000000000000000000etc
i i did try changing the hex number to the same number shown for the radar (figured that would be a higher sensitity than hydrophones)
but the results were just bizaare--
|
Yes, it is a long number and i really dont understand how to use the File Analyzer from TT.
I try loading Rule, Chose File button, but no way. I do not know how to use the program
.
About the emove of Crew rating, i remove all them from the u-505 and no way, the same behavior is still present, they are Ubber DDs.
