[CB..]

if you open the ai_sensors.dat with TT's analyzer and look for the hydrohones sensitivity you find the hex number--

sensitivity = 00000000000400000064000000420000001611FA


problem how do you set that to

sensitivity = 0 ?

is it

sensitivity = 0

or 000000000000000000000etc

i i did try changing the hex number to the same number shown for the radar (figured that would be a higher sensitity than hydrophones)
but the results were just bizaare--

i'm fairly stumped on this one might have to go for the ad hock method of just increasing the number of escorts until it's so difficult to get past then to reach the convoy that you don't mind if they don't react too much when you start sinking ships etc--bit of a mess tho