Hi Makman,
Having the bearing plate template will make it much easier now. I wasn't expecting to get that, hence the questions about what to do. I was expecting to have to work on one of the ones that already had the numbers on it, so things would be much more complex than my skill set. Now doing a simple layer will be much easier achieve, so thanx for the template.
I guess I only have one more question so that I can reduce my time spent:
What font did you use for the lettering? I should be able to figure out sizes just by comparing, but actually chasing down the font can be time consuming.
Again, thank you for all the hard work.
