SUBSIM Radio Room Forums - View Single Post - [REQ] Howto assign "Bumpmap/texture" to the water

urfisch · 07-25-11, 09:51 AM

Found the bumpmap, the water in sh4 uses. But theres simply no access to the foam files, nor to the foam controller, which manages when foam is created. Had the idea, in adding a foam with bump map to the normal sea movement (even while smaller winds). But even that was unsuccessful til now...

Interestin: The EnvSim.act file contains the mentioned controllers + additional controllers, which do not appear in the scene.dat. As so the missing foam texture controllers. But there are also no variables stored, afai can see. Disassambled the EnvSim.act and went to the 2 addresses which are connected with the foam controller. But there are not values stored.

Need help.

07-25-11, 09:51 AM	#2
urfisch Sea Lord Join Date: Mar 2005 Location: Deep down in Germany Posts: 1,969 Downloads: 42 Uploads: 0	Found the bumpmap, the water in sh4 uses. But theres simply no access to the foam files, nor to the foam controller, which manages when foam is created. Had the idea, in adding a foam with bump map to the normal sea movement (even while smaller winds). But even that was unsuccessful til now... Interestin: The EnvSim.act file contains the mentioned controllers + additional controllers, which do not appear in the scene.dat. As so the missing foam texture controllers. But there are also no variables stored, afai can see. Disassambled the EnvSim.act and went to the 2 addresses which are connected with the foam controller. But there are not values stored. Need help. __________________ Last edited by urfisch; 07-25-11 at 10:13 AM.