[Trevally.]

Originally Posted by reaper7

I've done some digging and noticed that the Memory address that I was using for the fix is also being used by not only Range - But AOB, Target Speed and Bearing.

So that explains the Reset to Zero Bug - All these dials are sharing the same Address's to store the value before updating the final value for the relevant dial.

So for example If i set my range its stored in this address, now if I change to AOB it resets to zero (Because the AOB is currently set at 0 degrees so that value is moved to the address) Overwriting the one for range that was stored there.

Fantastic find reaper

Hope you can fix it