I have a problem using the metod to make Very Fine Adjustments (moving vertical) to fine tune the actual radar bearing.
The vertical movement until the target pip fade in and fade out give me a variation af arround 20 degrees in the actual radar bearing. If I make vertical adjustements wen the target pip is at is maximum, I also get a variation of 6 degrees in the actual radar bearing, and that is not good to define the target couse!
So, can someone explain me the best way to get the most accurate value for actual radar bearing, using the vertical movement to get the fine adjustment?
(dont say " the best is wen the pip is at is maximum" that dont work! as it maximum I get 6 degrees variation!)
It would be realy good if whe have a switch to send range and bearing to tdc, the switch would be used after get accurate range and bearing, is that hard to mod or you can do that easy Nisgeis? It would be a must in your mod!
This one is the damned that is killing me
fine tune and... +- 6 degrees (deviation error) in the Actual Radar Bearing value ....
