Quote:
Originally Posted by razark
Like I said, my bearings have been 7 degrees off. To port. Rather consistently. If had a target at 000, I'd get a bearing of 353.
|
Trying again today. What I'm seeing against stationary targets is that I sweep the beam across the target. Once it's past the target (no blip on the A-scope), I crank it back counter-clockwise, until it shows up again. I then use the mouse scroll wheel to advance the beam clockwise two clicks. My bearings have been dead on. I don't know if this specific measurement is affected by range, but it was consistent with three separate targets.
Back to the radar training grounds.