Quote:
Originally Posted by Redlance88
Ok stop me if this has been done but the fact that the periscope heads stick out of the protective housings is driving me bonkers, So I figure it is a good a thing as any to make an attempt at doing a mod. Now I am starting with nearly no experience so I am gonna need some pointers and tips from folks who have more than I do. my plan is to just adjust how far the 3d object moves down in the Y axis but I am starting from zero without any knowledge of how things work in SH5 has any one been able to make changes to the 3d models or to the animations? I would rather just make them move that little bit lower than try to shorten them but depending on how they are built either might work. ( trying to avoid a gap of nothing at full extension). so looking for tips and advise on where to start. ( that means you Dark Wraith) or any one else that has some info on how to go about it. Thanks for reading look forward to hearing from ya all.
|
an obj_extensible controller (don't quote me as I'm going from memory as I'm out on jobsite and thus don't have access to my home computer) is used to control the periscopes movement. I would start with adjusting the values of that controller before attempting anything else
