[Bloomstomb]

Lurker is there any way to get the speed of the target from periscope view, or does it have to be done from the attack map.


For example, I dont see this.

"From the attack periscope, you have those two panels on either side of the view window that give you the torpedo settings. On the right panel there is a purple light, you can click that to lock and unlock the torpedo setting dials."


The only thing I have is 2 pullout thingies on the RIGHT side of the torp window. They are both the notepads.



Here is what I do see.

Type 7 uboat. Doing the 1939 campaign, started off in 7th flotilla.

Firt there is the attack perriscope window, I hit f4 to get to it. On the left side is my depth meter and periscope light. Periscope light does not work (no biggie for me but maybe its indicative of my prob). On the right edge I have to pull out tabs...

Top tab is Ship: Range: Angle on bow: speed:

Bottom tab is for my torpedo firing, shows I II III IV and under that V for fore and aft tubes. I also have a "lock" button, and a "fire" button , as well as a periscope up /down switch.

This is all I have. There are no dials, no lights to press and make torpedo dials pop out, nothing that pops out at me.

So is my install borked? Do I have to start from scratch?

I have uninstalled mods and reinstalled them several times with GME, snapshots show that my original copy of sh4 and uboat missions is the same when I uninstall all the mods. Mods seem to install fine, thoe I do get warning messages saying "might not work, do you wish to proceed", I click yes.





"If the light is on, then when you swivel the scope, you will see various dials spinning, and you will not be able to adjust them. Click the light off, this decouples the scope from the TDC and allows you to change the dials."


I dont see any of this in the attack periscope area.