SUBSIM Radio Room Forums - View Single Post

tomoose · 04-20-10, 09:05 AM

I'm assuming you mean you've physically dragged crew members into the damage control spots. You may need to fill all the spots depending on the damage. If you've done that then they will be working on the damaged parts. Go to your sub status screen (the tab with the cogs on it) and you'll see all the damaged parts in red (and your sub damage percentage in the upper left which IIRC if over 90 means you're basically SOL). In the bottom center should be a 'list' of the parts being repaired by priority with each one having a little 'bar' on the right side. If you mouseover this 'bar' it should display a number ratio. This should change if the part is being fixed.

Make sure you are not on silent running as the damage control won't do anything if silent running is on.

Lastly, it could be that your sub is simply too damaged to repair. Post a screenshot of your sub status screen and your crew status screen. This will help to nail down the problem.
good luck.

04-20-10, 09:05 AM	#2
tomoose Grey Wolf Join Date: Aug 2005 Posts: 930 Downloads: 23 Uploads: 0	Repair screen I'm assuming you mean you've physically dragged crew members into the damage control spots. You may need to fill all the spots depending on the damage. If you've done that then they will be working on the damaged parts. Go to your sub status screen (the tab with the cogs on it) and you'll see all the damaged parts in red (and your sub damage percentage in the upper left which IIRC if over 90 means you're basically SOL). In the bottom center should be a 'list' of the parts being repaired by priority with each one having a little 'bar' on the right side. If you mouseover this 'bar' it should display a number ratio. This should change if the part is being fixed. Make sure you are not on silent running as the damage control won't do anything if silent running is on. Lastly, it could be that your sub is simply too damaged to repair. Post a screenshot of your sub status screen and your crew status screen. This will help to nail down the problem. good luck.