Quote:
Originally Posted by gutted
Ok after a bit of hacking on the test version of the tracker...
I get this when using the example in the PDF... cant figure out why it's off:
Are we sure the solution in the PDF is correct? Mine was done mathematically with floating point precision and not drawn by hand.
Note: the above UI will not be the final version.. its just the previous version hacked to work with 2 groups of bearings. |
I too think the results (target course and speed) in the pdf are a bit wrong in that chart. I get a target speed and course when drawing by hand (177-ish) that is much closer to 180 degrees like your tool. My drawing shows a speed of 10.5 kts. But the method itself works.