Quote:
|
Every time I sent a torpedo, it goes too far ahead by a few meters, and goes behind the ship. Can't hit anything in 100 % manual mode. I'm using the in game notepad method.
|
As I was advised here, I advise against using the stock notepad method.
I have had instant success with the "fixed wire" method. The fixed wire method does not care about range to target.
Here is how you do it.
1) Drive your sub so that your 000 bearing and heading are pointed just in front of the target ship. If you point your periscope 15 degrees or so in front of the target ship and press "=" your sub will turn to that heading.
2) When your sub has stopped turning, your vertical crosshair should be in front of the target ship. Wait for the target ship to move until its nose touches the crosshair. Start your stopwatch by clicking on it. When the tail of the ship crosses the crosshair, stop your stopwatch by clicking on it. This gives you the amount of time it took the ship to cross an invisible wall in space, defined by your vertical crosshair.
The reason you need to be looking dead ahead or dead astern (000 or 180) while doing this is it negates the impact of the speed of your sub against the speed of the target ship.
3) Identify the target ship in your recognition manual. From there, you get the ship's length.
4) Use the following formula to get the target ship's speed:
(1.852 * Ship Length in Meters ) / Time in Seconds
5) Now turn your sub to come perpendicular (90 degrees) to the target heading.
6) Go to the TDC screen. Turn on manual data entry. Dial in the target's speed, and set the Angle on the Bow (AoB) to either 90 degrees port or starbord, depending on whether you are on the port or starboard side of the target ship. Turn off manual TDC data entry.
7) Go back to the periscope. You will notice now that as you turn your periscope, the gyro angle (under the notepad) changes. Turn the periscope until the gyro angle reads 000. This should be a little bit to the left or right of your sub's 000 in the periscope.
8) Open your torpedo outer door (Q key)
9) When the target ship crosses the vertical crosshair again, fire your torpedo when the crosshair is where you want to strike on the ship. I still go for dead-center to allow for inaccuracies.
If you measured the target speed correctly, the torpedo will hit the target.
Steve