View Single Post
Old 03-05-10, 09:34 AM   #306
jlederer
Bosun
 
Join Date: Jun 2005
Posts: 63
Downloads: 48
Uploads: 0
Default Filter buttons in scope

I tried using the buttons in the reco manual view to show me only the tankers with e.g. one large funnel but it didn't seem to work right. I was looking at a tanker with only one funnel and there were 3 choices: 2 funnels, one large funnel, and something else (one funnel?). Anyway I could see there weren't two funnels, but when I picked either of the one-funnel choices ALL of the tankers were filtered-out so I couldn't pick the one that matched the one I was looking at? Later it occurred to me that they might have done filtering the opposite of what I expected - maybe you can only "filter out" instead of "filter in" so I should have picked "two funnel" to filter-out all the two-funnel tankers? But then again, if that was true, then when i picked the one-funnel choices I should have seen some 2-funnel tankers to choose from and I didn't see any...
jlederer is offline   Reply With Quote