Quote:
Originally Posted by Tomi_099
I note that the piston in the middle does not move ... is that ok?
|
Hi Tomi,
piston = Kolben, du meintest aber wahrscheinlich Stößelstange/Ventil? Wie ich schon in meinem vorletzten Posting geschrieben habe, ist die mittlere Stößelstange nur zum Anlassen des Motors mittels Druckluft in Bewegung. Damit wird die Kompression im Zylinder verhindert, wodurch er in Drehbewegung versetzt werden kann. Die laufen wirklich nur für die ersten paar Umdrehungen mit, damit der Motor erstmal in Bewegung kommt. Dann wird gezündet und die Dekompressions-Stößel werden durch eine Mechanik von der Nockenwelle getrennt und bewegen sich nicht mehr mit.
Wenn wir Animationen in SH4/5 sogut kontrollieren können, dass auch das Anlassen vom Motor animiert werden kann, dann mach ich auch noch die Kurven für die Dekompressions-Mechanik.
-------------------------------------------------------------------------
as I mentioned in my next to last post, the middle push rod moves during engine start only. It's used to inhibit compression inside a cylinder when the piston is going up during the 2nd stroke. So the engine can get revved up. When combustion starts after few rounds of the motor, the middle push rod is decoupled from the camshaft and so the decompression mechanic isn't moving any longer.
If we can control animations in SH4/5 in a way to differentiate between starting the engine and normal run then I'll do the moving for the decompression mechanic too.