Quote:
Originally Posted by Bosje
owwww
holding the ring at the mastheight value and dragging it to the shiplength value, which sets up the ring to take an AOB measurement... that process most be 'reset' every time you do it by first resetting the target range!
so I was trying to get the AOB at a range of 1000 m while the AOB finder was still set up for 1500 m
it had nothing to do with touching the attackdisc or anything, obviously.
sorted, I think 
*wanders off to the idiot's corner and sits on a stool wearing a silly hat*
 |
Yes, that makes sense. Your initial post didn't make it clear enough (to me anyway) this happend at subsequent measurements. Your procedure seemed correct at first sight. The horizontal size you measure in the scope is also dependent on distance. (or else it would look very stretched-out when it is right in front of you) So you need to do the range thing again if a significant time has past since your last AOB measurement. "significant" depending on the closure rate of the target to you. The higher the rate the more quickly the last range-setting becomes old.
p.s. No need to sit in te idiots corner... you just got smarter!