SUBSIM Radio Room Forums - View Single Post

TigerShark808 · 07-08-09, 06:16 PM

because thats what I'm getting continuously. When I tell my Engineers "ALL STOP"..The top gauge reads "STOP" but the gauge below continues to read 2 knots (OLC GUI) and I continue on my way. Very frustrating when this happens for obvious reasons. Not unless I pull all my engineers out of there stations and put them to rest does the boat/engines actually come to a complete stop.

And once I put the engineers back into there stations AGAIN I accelerate to 2knots when the top gauge is reading "ALL STOP".

Anyone know why?

Thanks!

07-08-09, 06:16 PM	#1
TigerShark808 Engineer Join Date: Jun 2007 Location: 2074 nautical miles south west of San Francisco! Posts: 212 Downloads: 71 Uploads: 0	So ALL STOP means 2knots... because thats what I'm getting continuously. When I tell my Engineers "ALL STOP"..The top gauge reads "STOP" but the gauge below continues to read 2 knots (OLC GUI) and I continue on my way. Very frustrating when this happens for obvious reasons. Not unless I pull all my engineers out of there stations and put them to rest does the boat/engines actually come to a complete stop. And once I put the engineers back into there stations AGAIN I accelerate to 2knots when the top gauge is reading "ALL STOP". Anyone know why? Thanks! __________________ GWX3GOLD OLC "Gold" MkIId SH3 Commander D.I.D 100% Realism ! SWCs-AtlanticReaper Skin <---because it is badass!