SUBSIM Radio Room Forums - View Single Post - Webster's Mods are in the shop for repairs

Soundman · 03-22-09, 06:42 PM

Yes good luck. You are one of our "Mod Gods" here at Subsim. As a matter of fact, here's a request for you. I've tried to no avail to find a 3000 yd bearing tool that works with a 16:10 resolution ratio. Unless I've missed something, many folks are in the same boat.. (no pun intended lol). It would seem the tool is proportioned correctly on the map (it's round), but the scaling measurments are considerably off yardage wise. Any suggestions? Thanks in advance.

03-22-09, 06:42 PM	#5
Soundman Commodore Join Date: Jul 2006 Location: Orlando, Fl Posts: 617 Downloads: 60 Uploads: 0	Yes good luck. You are one of our "Mod Gods" here at Subsim. As a matter of fact, here's a request for you. I've tried to no avail to find a 3000 yd bearing tool that works with a 16:10 resolution ratio. Unless I've missed something, many folks are in the same boat.. (no pun intended lol). It would seem the tool is proportioned correctly on the map (it's round), but the scaling measurments are considerably off yardage wise. Any suggestions? Thanks in advance. __________________ RVAH-9 RA-5C Vigilante at NAS Sanford, Fl 1966 The coolest plane few have heard of!