Quote:
|
Originally Posted by danlisa
In GWX 2.1 & Gold there are 2 Bearing.tga files (bearing.tga & bearing2.tga).
Bearing.tga is the original scale from Stock SH3 and is used by the Binos & UZO.
Bearing2.tga is a blank file (alpha channel only) I created to allow the bearings to be removed from the binos in GWX 2.1 & Gold, while leaving the UZO untouched.
The only way to re-enable the bearings in the Binos in GWX is to open the 1027_768Menu.ini in Notepad, press Ctrl+F and search for the only entry 'bearing2.tga'. Then rename this to bearing.tga. GWX will then use the original file that I left in there.
|
Danlisa, with all due respect, since it sounds like you created this mod for GWX2.1 and Gold, the bearing tga file controls the scopes, uzo & binos in stock SH3. The bearing2 tga file is used in GWX2.1 & 3 for the binos only.
I have, in fact, copied the bearing tga file, renamed it bearing2 and pasted it into the GUI folder (overwritng the GWX bearing2 file), thus giving me bearings in the binoculars. Note: do not mess with the bearing tga file, leave it alone.
I have taken this one step further I might note, someone provided me with a bearing file that uses 1-degree intervals instead of the stock 5-degree intervals. I then substituted this 1-degree bearing file for the 5-degree bearing file in the Gui folder.
The results: 1-degree bearings in the scopes and uzo; and 5-degree intervals in the binoculars. Take it from me, this does work! But, you must be careful and substitute the correct bearing files or it could get messed up. I've created some of my own JSGME mini mods to do this with.
I would like to find a bearing mod that uses 45-degree intervals(0, 45, 90, 135, 180, etc.), if this is possible. I think that this would be more realistic in the binoculars.