Quote:
|
Originally Posted by Siara
MX- the trick is to use the drill on inside, and look against the light. When the plastic becomes so thin that the light starts to shine through the plastic, all you need to do is to push the hole through, and you end up with clean hole. You dont drill the holes, you thin the plastic on inside using one of round router tools. Make sure you go slow, as speed melts the plastic.
Did you check the other link?  |
I can see i have much to learn on buildding submarines
Thank you very much Siara! I will try to do this your way, and report back, but i guess not before next week, since i need to get the drills first
Do you think this method will work with the smaller holes swell? maybe i'll try to drill out them all
But than again it would mean lost of covering/masking them on the inside later, i wouldnt want to end up with a see-thru effect.
I need an opinion on this
And yes, i did see conus00's build, i've found it when i was doing my research on XXI type models. Not many people seems to build those, even less are showing their builds on the web.
Thanks again Siara
