SUBSIM Radio Room Forums - View Single Post - how to set the correct deep for torpedoes?

itman · 12-12-08, 05:33 AM

I'm a bit frustrated about the torpedo-deep-settings. The game was in metrics-mode and the torps ready for impact. So, I'd open the ship-ID there's a value for draft. When setting up the torpedo I do set the desired deep with the weel on the left side. Example: draft of target 12.4m -> torp set at 10 m. When fired, this eel just run undert the target. Happens several times.

Next approach. I thought. "ok this is an american boat, so no need to stick to metrics" I've switched to inches and yards.

Setting up the next torpedo-run I see indeed different values for draft. Again I'm unable to setup the correct deep for impact. This one too runs just to deep for impact.

Did I miss something?

12-12-08, 05:33 AM	#1
itman Seaman Join Date: Aug 2008 Posts: 41 Downloads: 156 Uploads: 0	how to set the correct deep for torpedoes? I'm a bit frustrated about the torpedo-deep-settings. The game was in metrics-mode and the torps ready for impact. So, I'd open the ship-ID there's a value for draft. When setting up the torpedo I do set the desired deep with the weel on the left side. Example: draft of target 12.4m -> torp set at 10 m. When fired, this eel just run undert the target. Happens several times. Next approach. I thought. "ok this is an american boat, so no need to stick to metrics" I've switched to inches and yards. Setting up the next torpedo-run I see indeed different values for draft. Again I'm unable to setup the correct deep for impact. This one too runs just to deep for impact. Did I miss something?