|
Failing to apply SCXII
hello
i'm crying for help: i've installed & applied SCXIIc but it couldn't be started the game any more i.e. once it is started SubCommand, it shut down at once... could anybody explain why & the entire installing procedures...? thanks a lot wong tat |
There are a couple of .bat files you have to run before SCXIIc will work, in case you haven't already done so...
1) Go to your Sub Command\Graphics folder, there is a file called Install_Graphics.bat. Run it, it usually takes a while so be patient. 2) Go to your Sub Command\Interfaces\AkulaII folder, there is a file called Install_Loadout.bat. Run it as well. These are the two steps I missed the first time I installed SCX, and I was having the same problem. Hope this helps! |
Yeh as Ultraboy said - just right for SCX and if you go on to SCX2 you have to run another Install_Graphics.bat.
Might help to rename the SCX one post install (I think you can remove it ) - that ensures that subsequently you dont rerun the old one rather than the later addition. Happened to me. :down: |
Wong - did you get up and running ok ?
|
| All times are GMT -5. The time now is 10:37 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.