![]() |
Return to base?????
Ok, I'm new to SH III, I'm in the training missions, training on the deck guns, when I sink all the ships I get the message that I've passed the requirements, and return to base.
How do I return to base? I push the escape key, and return to the previous screen, quitting the mission, but when I get here, it says that I was unsatisfactory in this mission, what am I doing wrong? Thanks :roll: |
I always sail back to port. Come to full stop near the quay (where the band is). And then press escape. Always get full points.
But I believe getting as near as a few miles near port will do the trick as well. |
I do too -- except for St Lorient ;)
|
Ok, how do I find the port it's not marked on the nav map?
|
He is in Training, I doubt there is a port.
|
Quote:
Normally you should follow orders (check the "orders screen") and keep checking for radio messages. You will get a message when your task is about completed. |
In regular missions:
Upgrade to 1,4 and have the port in detail on the map at a proper zoom level. Once you are within the lighthouses, you can safely press "Save and exit" and then "Dock at: <portname>" In training missions, just press esc. :D |
I think if you get within 30km from base, you can exit and get full renown for returning to base.
|
Training missions should end automatically when you have completed them. Or at least you'll get a pop-up window asking if you want to quit now or later(?).
So just go to time compression for a while, or at least wait until you get the pop-up window. It sometimes take a while, if I remember correctly. |
Nope, you have to hit ESC.
|
Quote:
I remember I took out the ships in 'wrong order' on one of the missions. I completed the primary objective first, and the mission quit and I didn't get a chance to complete the secondary objectives to get a full score. So I did the mission again, this time doing the secondary objectives first. Then the mission quit when I completed the primary objective and I got a full score... :ping: |
Doubtfull, it probably said Mission Completed but it didn't return you to base automatically.
|
Quote:
|
Ok, the mission doesn't end automatically, I sailed around in circles after the sucessful completion box popped up, I the pressed escape, and return to base, and still it says unsatisfactory .
:hulk: |
Ending any training mission submerged will always result in a failure regardless of step completion. Were you on the surface when you tried to exit ?
|
All times are GMT -5. The time now is 04:35 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.