Unable to patch SH3.exe
 

I have installed SH3 from scratch using my Direct2Drive download purchase. It installs as 1.4. This appears to be 1.4b.

I downloaded the V16B1-Patch-Kit

I am running Patch_SH3.bat as administrator, and my original SH3.exe is in the folder with it.

It says no compatible version of SH3.exe found.

Any ideas?

Steve

Yup, I just did a complete uninstall and re-install of SH3, then copied the file into the folder with the bat file.

When I try to run the bat file, it says it's not recognized.

Product version of SH3.exe is 1.4.0.1.

It is not read-only.

https://i.imgur.com/TsLgXXY.png

Steve

I'm running Windows 10.

Steve

I can make new files in the folder so it is not a permissions problem.

Steve

ok just ran it again by a simple double-click and it worked.

Steve

Hi mm
That I would find frustrating and annoying but also a relief.
Peter
https://s14.postimg.org/7i754ejk1/image.png

Hello I'd like to continue this thread because I have the same problem and I still don't know what to do to fix it.

I have my sh3.exe in the V16B1 folder with (I guess) removed read only attribute, also I have installed GWX3.0.

1.4b patching
 

I cant patch my SH3 Steam Version to the 1.4b patch..

I just get a message that it cant find the MissionEngine.dll .. but it's there of course. What can I do?

A Warm Welcome To The Subsim Community > Blutenburg
Subsim <> Make A Donation <> See The Benefits <> Support The Community
SH3 – 4 - 5 Tutorials > Downloads > Other Useful Information > See Links in My Signature Below

Make sure your exe applications are set to run as administrators.
I am sure someone who has some STEAM knowledge will be able to help you.

Note > You must run Windows 10 in compatibilty mode for Windows 7.
Make sure your gpu is set correctly to run SH games.
Post #7 Changing Nvidia And AMD Radeon GPU Settings > Pictorial

https://i.postimg.cc/jdTWx9Zg/lsh3-dev.gif

Welcome aboard!
 

Load it up. As it's loading look in the lower right-hand corner. This will tell you which version is running. It may already be 1.4b, in which case you're good to go. One note: It won't say 1.4b, it will just say 1.4. A mistake on their part, but there it is.

Of course it may not already be at that level, but one thing at a time.

If problems persist, you might want to try this:
SHIII_1.4b DiscScratchProtector Utility By Maik
http://www.subsim.com/radioroom/show...59&postcount=1

I had a problem with "sh3 not found" and used a similar archive from another site that had the files the installer was complaining about and got past the error

While it is setup to remove Starforce Protection, it has updated SH3 files in it that you could place in your directory to see if it gets past those "file not found" errors
Unpack and copy the files reported missing into your installation folder.
https://www.mediafire.com/file/9z1bf...+Power+Pack.7z