![]() |
Narvik Single Mission
I just did the Narvik mission to drop off SF. I searched like crazy for the "deploy" button, tried at depths to the point of the tower out of the water (bad idea) and the XO failed to have any reports.
I finally got out of there to exit without the helos around and the mission said I sank everything, but nothing about the SF. I searched through the manual for different words and nothing pertinent came up. Any thoughts? Thanks, Del |
Narvik Single Mission
For the SEAL team to deploy, the following conditions must apply:
1. The sub is in the blue deployment zone (a small circle marked on the plot). 2. The sub is shallower than 100 feet. 3. The sub is slower than 5 knots. You should get a message once the sub enters the deployment zone and another once the team is away. In your attempt, did you meet all the conditions? |
Yes, easily.
I do have to say that I was not paying attention to the message board since so much was occurring. I guess I will have to try it again. I do like the floor and its sloping. I stayed pretty much within 50ft to avoid some of the hounds. I know that the control room is not depicted, but being able to see a light flash when the hatch opens would be nice. I guess that goes for those that want a control room. I just want info. Thanks for the info. |
I went back. Rather easy. Surprised that the Foxtrot ran and sat next to a beach. No bikini girls on the beach either...
Anyway, no notice of "Skipper, we are at the release area". And nothing at the mission results page. A little more aggressiveness, and bikini girls for periscope perusing. |
All times are GMT -5. The time now is 10:43 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.