![]() |
Grafical Issue
Hi!
I began playing SHV a few days ago. I followed the instructions to install TWOS (v1.05) on a fresh install without entering the game until the megamod was enabled (well... I entered to start the campaign as shown on the TWOS install isntructions but exited the game as soon as the cinematic started). I actually have these mods enabled: Generic Mod Enabler - v2.6.0.157 [F:\Juegos\Silent Hunter V\MODS] 1. The Wolves of Steel 1.05 2. The Wolves of Steel 1.05 - Update No. 13 3. The Wolves of Steel 1.05 - Real Navigation_by TheDarkWraith The game seems to run fine but on the firs campaign mission I began to watch this issues as soon as I was inside the patrol area and near of enemy contacts although no contacts were detected at the moment when the issues began. This is what I see in the game, Note the upper left corner http://i104.photobucket.com/albums/m...psogdvgh1n.png More examples http://i104.photobucket.com/albums/m...ps0nz7hc6f.png http://i104.photobucket.com/albums/m...psqqyhvfq1.png http://i104.photobucket.com/albums/m...psc7lyuqkh.png All these "smokes" appear randomly and only at certain camera angles. I see them, if I turn the camera to certain angle they disappear. But taking the camera where it was before the "smoke" pop up again. If I maintain the camera on the position where this "smokes" are, after a few seconds, they began to fade or just disappear. Any idea/solution? Greetings from Spain. Un Saludo! Edited: If I use binoculars to look at the "smokes" they simply are not there. I exit from binoculars and the "smoke" is there again |
Known stock game issue when some "smokey" units are around, no fix...You'll get used to it...:)
Welcome ! |
Good to know, a pity that it has no fix.
Thanks for the answer! Un Saludo! |
All times are GMT -5. The time now is 12:58 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.