hunter301 |
03-09-14 04:31 PM |
How accurate are the renderings for the landmasses?
Last night I was running the quick mission war patrol were you have to sneek in and sink the Yamato.
I was doing fine under normal time compression. Snuck past the two jap fishing boats in the entrance so they didn't radio in my location.
Got within 3,000 yds. went down to 150' full speed got past them resurfaced at around 2,000 yds in front of them because my batteries were down to about 10% surfaced, went to full speed and plotted a course that kept me in the middle of the land masses on both sides. Due to time constraints, mainly it was getting late I was used time compression to 32x. I was mostly going by my navigation map but just after turning on my first leg to a heading of about 035 all of a sudden I'm getting damage reports. Hull breaches, damaged periscopes, engine room damage, fires,etc....:o
At this point I was pretty much done. All tubes damages, deck guns, everything. It was like I ran into a damn mountain or something.
At the time I had gotten no radar warnings and no ships in the area.
Radar had reported a contact but it was 7 miles out in front of me.
The only thing I can figure is that I hit something. What I don't know. Could it have been a land mass? I was moving pretty fast across the map so I wasn't outside looking at what was around me.
|