Problems New Interiors
 

I Have Problems with FM_NewInteriors v.1.0
Whenn i go in the Mashine Room and i change the Speed, the PC shut down> Bluescreen !?
And when i use the Periscope there is the same Problem, a Bluescreen and the PC goes Down.

Sorry for my bad english...

Wenn es hier Deutsche gibt,
Immer wenn ich in den Maschinenraum Gehe und die Geswindigkeit ändere Kommt ein Bluescreen und der komplette PC schmiert ab.
Zudem gibt es eine Möglichkeit durch die Shotten zu gehen, ich muss mich immer mit F2 darumarbeiten:down:

Welcome to Subsim f6l913!
 

:salute:

What are your system specs? Because FM Interior is quite a demanding mod. 3 or 4 gig memory is recommended for this one.

Also, there is a free camera mod so you don't have to press f2 when you want to walk around the ship, but I'm not exactly sure where I found it. Try searching the downloads section for that one. :salute:

If you're running other (memory) 'heavy' mods, you might want to temporarily disable them and then try to replicate the issue with New Interiors.

Also, there are a number of 'fixes' available that make other mods compatible with NI, so you may want to check your mod list and see if there are any potential conflicts.

Aside from that, Bakkels is quite correct in suggesting you may need the 4 GB patch (along with the corresponding amount of RAM) in order to successfully run it.

Good luck! :sunny: