![]() |
Hogan and crew dismisal
Greetings,
I've not long moved from SH3 to IV (testing the water) and have TMO mod installed. I have started a new career and two things puzzle me. Crew management; What is Hogan's alley and what do crew placed there contribute to the well being of my sub. I want to 'dismis' some of my crew and 'enlist' some experienced men fron the personnel shown as available on the left of the management screen but but the how eludes me. There seems to be no 'dismist/enlist' method similar to that found in SH3. I've tried draging and dropping and random key strokes without sucess. Some guidance please. On my first career, quickly ended, I noted that TC did not return to 'normal x1' when I was sighted and subsequently atacked and sunk. Dead within seconds! TC for various conditions could be set in SH3 is this posible in SH4? |
Quote:
Quote:
Quote:
|
Thanks razark for the reply.
Seasonal greetings, a fair wind and snug harbour to you and your 'crew' |
In regards to TC. One thing to remember is your PC has to read each contact, then it comes to you and continues reading each contact. The danger of TC is you may try to be slowing it down as it's reading the contacts, but you're still moving, so by the time it comes to you, you may be dead.
The best thing to do is the moment you get pc lag, the give away that ships are in your contact zone is to stop TC in one step by going to one of the sub stations, I use F2, so I go to the control room. If you try to slow TC down a step at a time, say going from 3000, 2500, 2000, you're still going forward and by the time your PC gets to your turn reading contacts your dead, so do it in one step by choosing a compartment to go to. A lot depends on your system, the better it is, the faster it reads and the quicker it reacts. I know when I first started playing I got killed a lot beating on the minus TC button trying to get it to slow down in stages. |
Quote:
In TMO backspace is used to set TC to 1, in stock it pauses TC. |
Thanks every one for the replies. All read with much interest.
|
Quote:
Thanks D40:salute: |
See post #5 please... :D
If you set TC to 0 for every contact, I'll bet you very soon will change it to 1 (or more)! :rotfl2: Anyway, here's the complete TC list from main.cfg (note, you'll look in your documents folder for this!): [TIME COMPRESSION] TimeStop=0 RealTime=1 LandProximity=4 CriticalDamage=1 CrewEfficiency=128 AirEnemyDetected=1 SoundEffects=2 CharacterAnim=4 EnemyDetected=8 RadioReport=8 Particles=8 PrayState=8 HunterState=32 3DRender=32 Maximum=8192 |
Quote:
|
All times are GMT -5. The time now is 11:05 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.