Where is the stadimeter?
 

Miserable enogh, I can't find stadimeter :oops:. I dont' use any Gui mods but still the periscope screen looks a lot different than normally. On the right are all TDC buttons (speed, AOB etc.). I looked all over the place but can't find that stadimeter.

The stadimeter is part of your Attack periscope and UZO, used to range a target.

Determining range to a target of known height is a simple problem, so the first step
in any attack is the identification of the target. Bring up the Recognition Manual
(shortcut: M key) and flip through it until you find a match with the target you are
looking at through the optics. Check the empty box on the manual’s page. This will
identify the ship in question and automatically enter the mast height – the tallest
object on the ship – on your notepad.
HINT: It’s easier to identify a ship when looking at it from abeam (90° to its side).
Click the Range section on the notepad, which will open it to the correct section.
Once you have the target’s correct height from the ID book, all you need to do is read
its apparent height (as angle ) from the periscope or UZO. Both optics are fitted
with marked reticles for this task and a Stadimeter-like tool to automatically measure
the target. The meaning of the reticle marks can be read in the table below:
OPTIC USED SMALL MARKS LARGE MARKS
Periscope (1x or 1.5x) 1° 5°
Periscope (4x or 6x) 0.25° (0°15') 1.25° (1°15')
UZO (7x) 0.2° (0°12') 1° (0°15')
To use the Stadimeter, first place the crosshair on the waterline of the target.
Next, click the icon in the lower left corner of the notepad. Your mouse cursor will be
captured and will be used to move a horizontal line in the periscope view. Place it on
the target’s highest point – the masthead. When satisfied with the approximation,
left-click and the range will be automatically calculated in the notepad. If you agree
with the results, check them to return to the main page of the notepad.
http://img.photobucket.com/albums/v6...stadimeter.jpg

hope this helps
Fido U-52:salute:

Thank you for your help but the problem was not that. I just found out that apparently I have some time ago installed Hitman's Modified Optics for GWX mod (which removes the stadimeter completely) and later on uninstalled it but the mod still was not remove and for some reason remained installed. Sorry, Fido. You had to see a lot of trouble helping me :oops:.

Good Hunting
Fido U-52 :salute:

I got it working. I tried to install a mod which would overwrite the old GUI files and then uninstall it. Now it's normal again. I hope my little (but still very annoying) problems would be finally over and I could breathe the Atlantic sea air freely, until I get sunk by a destroyer.

Good hunting to U-52 as well! :salute: