![]() |
My homemade telescope...
As promised in another thread here are some shots of my home made telescope.
I had to tear her down to get ready for winter and blow out a few cobwebs and such. Only the optics and finders were 'purchased'. It is a 6" f8 newtonian (dobson) reflector. These pictures are a little out of order but its un-important. http://i259.photobucket.com/albums/h...m/DSCN2016.jpg Front looking down http://i259.photobucket.com/albums/h...m/DSCN2015.jpg Side view showing the altitude bearings. The round things. It 'glides' on teflon pads which are just visible. The entire base rotates for azimuth adjustments. Your typical dobsonian mount. http://i259.photobucket.com/albums/h...m/DSCN2001.jpg This is the main mirror and mirror cell resting on the table after cleaning. http://i259.photobucket.com/albums/h...m/DSCN2003.jpg Another mirror shot this is a vain attempt to show its scale... its 6" :doh: http://i259.photobucket.com/albums/h...m/DSCN2004.jpg Here is a shot of the diagonal mirror holder aka the spider. The diagonal mirror is allegedly optical 'flat' and re-directes the foucus 90 degrees and up the focuser. http://i259.photobucket.com/albums/h...m/DSCN2005.jpg A peek down the focuser 1.25" ... cobwebs.. yuk. http://i259.photobucket.com/albums/h...m/DSCN2006.jpg An overall view of the 'tube' its really a box but we still call it a tube :88) http://i259.photobucket.com/albums/h...m/DSCN2008.jpg This is the ass end of the scope tube showing the collumnation screws. The three screws are adjusted to align the tilt of the main mirror. http://i259.photobucket.com/albums/h...m/DSCN2009.jpg Here the mirror cell is in place but left loose to show the adjustment screws. A funny side note the screws but up to pennies glued to the mirror cell to keep the screws from digging into the wood. http://i259.photobucket.com/albums/h...m/DSCN2010.jpg Outside view of the collumnating screws. The middle screw holds the cell in place the three outside screws do the adjustment. http://i259.photobucket.com/albums/h...m/DSCN2011.jpg Theres been quite a few mods over the years the most signifigant was these finders. Both a right angle 'scope' and a reflex sight. The original finder was a pair of screw eyes :haha: The reflex sight places a red dot in the sky when you look through it. If all is well place the red dot on an object and it 'should' be centered in the eyepiece. The spotting scope is a bit more accurate and easier to see faint objects. http://i259.photobucket.com/albums/h...m/DSCN2013.jpg Of course adding all that weight from the finders to the end of the scope threw it out of balance requiring this kludge. Thats a plastic screw container filled with led shot mixed with expoxy. Thats about it for now... enjoy ! |
You're a Subsim forum Thomas Edison! :yeah:
|
NICE!:up:
|
Nice telescope... so what is its magnification?
|
Quote:
It all depends on which eye piece you put in. Eyepieces are as varied as the day is long my 'highest magnification' eyepiece is a 7.5mm vixen lanthium which gives and effective magnification of around 162x. At that magnification it is no small feat to keep the object centered in the eyepiece as it will corss the entire field of view in less than 10 seconds. Not to mention getting it centered in that narrow view to begin with. My favorite eyepiece is the 28mm plossel (university optics). It has a nice field of view passes alot of light and has very little edge distortion thats around 37x and the object stays in the eyepiece for at least 20 seconds. Easier to chase. It is an f8 at 6" which makes its focal lenght around 48" at that point the incoming start light is focused. Its up to the eyepiece to magnify that focused image. Its easier to use the calculator web applet instead of going through alot of math... http://www.csgnetwork.com/telescopemagcalc.html# By the way it is easy to see jupitor and her moons through the 28mm with the 7.5 you can see the moons shadows on the planet ;) Not to mention the red spot. |
Nice instrument there Steamwake. I imagine you can capture some faint deep sky objects like galaxies and such with that when you set up somewhere rural. :up:
I have an 8" Celestron, but it mostly lives in storage these days. |
Quote:
But I sure know how to bring the clouds and rain :rotfl2:works better than washing the car !. |
All that work just to peek in your cute neighbour's window when she is changing clothes???
:D |
Quote:
|
Quote:
http://pyxis.homestead.com/SkyGazin.jpg |
You mean crawling into your arms?
The night is dark and cold, the stars are twinkling romantically and you just impressed her with your wits on astronomy. Suddenly in that twilight hey suddenly she thought you're not so bad after all and you capitalized on that :O:. |
I wonder if that would let me look in through my girlfriends window, 25 km away from the top of my house. The curvature of the earth should will probably get in the way though, hmmm:hmmm:
|
Quote:
|
All times are GMT -5. The time now is 10:04 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.