tdc stuck
 

Hi,
I have a strange problem with the tdc.
It gets stuck. Can`t alter the distance to target and aob.
Yes i know i can alter the light from red to green or visa versa.
But this problem stays.

I am using the olc gold mkII mod.

Which file is it that steer this?

If you figure it out, let us know!

Seriously, up until today this is still a mystery-bug in OLC's GUI. The only solution I know (remember) is to go to the TDC station in the 3d internal view, and press the TDC auto/manual button on the device. After that the tdc dials should work again.

That`s right pisces, but now i have it always.
For every alteration i have to set the lamp to green and
after that to red. In the past it was sometimes.

That's the first time I've heard of a continuously sticky TDC. I allways had to click the knob just once. Never twice. Are you sure you didn't put it into the bad state again by clicking the second time?

No :(

But when i install the manos or the mihayl gui over it the problem is gone.

But i want to keep the olc gold gui.

I don't know anything about those other mods. But OLC Mk2 should work normal. I have the same OLC mk2. Have you enabled other mods aswel?

Yes, today the mihayl mod over it.

So did you have this problem before you installed Mikhayl's mod, or after?

If before, then that's strange. It suggests to me a broken commands.cfg file. Did you recently use a program that lets you change key mappings, such as SetKeys or similar?

Hi olc,

I have installed the command files from your mod after i deleted the mihayl mod
and it works great again !

Thanks a lot !!

:salute: