GWX SH3CDR install question
 

OK. So I think I've got it;
I need to d/l:
1. GWX.exe
2. GWX103.exe
3. SH3CDR27.rar
4. GXW102Cfg4SH3Cmdr

Do I need to d/l all the gwx-1. bin etc. files too?

The instructions say to d/l all files into the same folder(?) then run the GWX.exe. But I dont know how to d/l them to the same folder and then run the GWX.exe?
any help , thanks

Get all the bin files and the executable (GWX.exe) in the same folder. Run the executable and follow the on-screen instructions on the installer.

OK, thank you.

Then inorder to intsall sh3 cmdr I have to install those too. I'm going to read the manual carefully to try and figure this out.

thanks again.

Whew, here we go:
I am going to install these in the following order.
1. GWX.exe
2. GWX-1.bin
3. GWX-2.bin
4. GWX-3.bin
5. GWX-4.bin
6. GWX-5.bin
those go into the same folder and then run GWX.exe

7. GWX103.exe

Then for SH3 CDR install:
1. SH3Cmdr v. 2.7. rar
2. SH3cfg4sh3cmdr.zip
3. sh3cmdrAM.7z
4. GWX_-_combined_skin_pack.7z

wish me luck!

Luck ;)

Don't forget to use JSGME in the SH3Cmd Folder if you want to install the Aircraft Markings and the GWX Skin Pack.