Manual TDC/Position Keeper Questions
 

Hi all!

I have a couple quick questions about the manual TDC in SHIV.

1) Why would you ever want the Position Keeper switch "off".

2) After setting up a solution, I'd like to allow some time to elapse and verify that solution by comparing the TDC generated bearing with the actual target bearing. But I can't find where the TDC reports the targets new bearing.:doh:

Bump for a new day! This has me puzzled, but there HAS to be an easy solution that I'm just missing... thanks in advance!

I'd like to know too because that was what made the TDC above and beyond better than anything else at the time and I still haven't figured out where the TDC generated bearing (not gyro angle) is.