Do you get bubbles when you laminate those inkjet transparencies? That's what happened to me when I laminated mine :{

You have to be careful. Go slowly, and if you see a bubble developing smooth it out while there is still a place for the air to escape.

Failing that, take a pin and poke a tiny hole in the lamination at the center of the bubble. Smooth the edges of the bubble inward towards the hole.

Really nice find and nice work!

Neal

I'm disappointed, Neal. I was hoping you were going to announce that you would be selling a 'Subsim Special Edition' Banjo. :cry:

I was looking at this link today @ work, that someone posted in this thread earlier, it shows the original instructions.

scroll down to the bottom for a really nice pic.

http://www.hnsa.org/doc/attackfinder/index.htm

How much?

:rock:

:88)

:sunny:

Argghhh you ruined the surprise! I have been looking here at local plastic stores to see how much they would ask for doing them in laminated plastic:x

Well, if it looks as good as the one in this link http://www.hnsa.org/doc/attackfinder/index.htm i'll take one

That's not a banjo, THIS is a banjo-

http://hnsa.org/doc/banjo/img/pl1.jpg

Mk8 Torpedo Angle Solver

http://hnsa.org/doc/banjo/index.htm

Referenced as being used on S-27 when she ran aground on Markarius Point, Amchitka.

Yours, Mike

I have finished the templates and have already built mine:rock:

Here are the printable images in BMP format for everyone to build and enjoy: http://rapidshare.com/files/28399815...S-WAS.rar.html

Have fun and sink 'em all!

Excellent work, Hitman, and tnx.

:rock:Thanks

Woohoo!

Thanks Hitman.

For some reason it didn't come out the same size as my other one? no biggie I just use it separately.