I think for Type IIa is the attack and air target periscope swapped. If I am right, the attack periscop must be be the rear periscop.


Here is a screenhot of the curent model:
https://i.postimg.cc/8cgc6sPn/2021-07-27-132742.jpg

On submarines of the Typ II, two periscopes were installed: in the middle of the central post compartment, closer to the stern of the submarine, was the working part of the anti-aircraft periscope, and closer to the bow of the submarine - the commander's periscope shaft

One additional question about your version of GUC. Have you also working victory pennants integrated?
I ask, because I tested at the moment only type IIA and there are no pennants, if I full raised periscope in harbor.

There are no pennants of victory and there will not be for technical reasons.

Hi Anvar1061,


Just out of interest, what technical reasons stopped you from using this mod,
as I am thinking of using this mod in my current GWX install ?

One periscope is used separately on all Turms through the library.

I remember a long time ago I had a mod that fixed that issue and swapped the position of the two scopes for the type VII's so they would be correct. I've been looking for it on my backups but haven't been able to find it. I also had a mod I think called Church's Observation Scope that changed the GUI periscope view so you could see higher and lower.

I have already explained above that the periscopes are placed correctly and there is no need to reinvent the wheel.

How exactly do i install this? I downloaded part 1 and 2,used winrar and clicked on "extract here",which combined them.Then i moved the folder into the mods folder.This is how I've been playing like this for all of my patrols,but i'm not sure if i installed it right.Do i have to install them separately?

Yes,i have it enabled,i just wasn't sure if i installed it correctly.

Yes,but if you playing with GWX3.0 must be GWX_Fixallsub installed too,and look this opinion https://www.subsim.com/radioroom//sh...&postcount=286

I have that too.But why do the keyboard commands not work? If i press shift+N,or ctrl+n,the UZO doesn't appear.Same with the observation periscope,if i press shift+o or ctrl+o,it doesn't go down.What do i do? Here is my modlist:

Put GUComp over the top

You can find them here ;

https://www.mediafire.com/folder/zlz5mx2gbm2zg/Church

Good hunting,
FUBAR295

I still can't get it to work.I downloaded the sensors fix for gwx,the new u-boat guns mod,and i also downloaded the german u-boats compilation 2.I tried putting the mod on the top but it didn't work.I saw some people here mention a shortcut mod,where can i find it?